Complete the sketch by removing the stylization that is hanging on the character. The amount of stippling is small if drawn only once, so it looks like this if you draw the same part repeatedly about 6 to 8 times. (If it is made of binary data, 1bpp layer is also acceptable.) By adjusting the brush diameter according to what you want to draw a stippling, we will draw around the border of the selected area with a stippling brush. Invert the selection, create a new 8bpp layer and draw a stipple. Place the cursor at the center of the snap and specify the selection range round to the green line. Select the ellipse selection tool and check 'Center' and 'Fix aspect ratio' in the tool option. First select the concentric circles from the snap settings and set the snap center around the center of the green circle. (It's hard to understand if it is a thumbnail) I will draw in a sketch along the green circle in the figure below. (Resolution 600dpi, 5cm vertical 8cm) I will put a pointigraph on this image like a firefly brush. I prepared an image to put a point sketch. ★ By the way, if the document is created at a resolution of 300 dpi, then the size of the point 'dot_max / px' is simply doubled to 54, and the 'interval' is about 9 and it feels just right. By setting the parameters in this way, it is possible to create a point drawing image close to the firefly brush created by Katsumi Dohara. With reference to the image of this firefly brush, I checked the setting value of the size and density of the point suitable for the resolution of 600 dpi.

Cats and crabs įirefly brush from here　brush　(the publication of a abr file) If you use a brush such as Photoshop, it is an image that you can easily create a sketch. There is an image for the brush 'Firefly Brush 2' on the site of the cartoonist Katsumi Dohara.

Firealpaca binary brush